CHECK EVERY ARROW, EVERY SHOT

WARNING: FOLLOW THESE INSTRUCTIONS TO AVOID PERSONAL INJURY

ARROW DAMAGE

Any arrow can be damaged, even when new. A damaged arrow could break upon release and injure you or a bystander. If you have any reason to believe that an arrow has been damaged, DISCARD THE ARROW.

Damage to an arrow shaft, or any of its components, may occur from improper transport, handling, or use; impacts with hard objects or other arrows; or after being shot into a game animal. No list can cover all possible conditions and situations that may cause damage. Use good judgment and common sense to determine if your arrow has been damaged in any way.

WARNING! NEVER SHOOT A DAMAGED ARROW.

ARROW USE PRECAUTIONS

Before each shot, including the first shot of a new arrow, carefully inspect each arrow shaft and all arrow components to make sure they have not been damaged.

Place the arrow between your thumb and fingers and, using your other hand, slowly rotate the shaft. Run your fingertips along the entire arrow length while looking and feeling for nicks, cracks, splits, dents, or other marks that could indicate the shaft has been damaged.

If your arrow is crested or wrapped, inspect the surface for damage and check for any soft spots beneath the crest or wrap. You may need to remove the cresting or wrap to perform a thorough inspection.

If damage is present, DISCARD THE ARROW.

WARNING! NEVER SHOOT A DAMAGED ARROW.

A loose or damaged nock may indicate a damaged arrow shaft and can be dangerous. Before each shot, inspect the nock for damage and make sure it is fully seated and fits tightly in the shaft.

Apply twisting pressure to determine whether the nock turns easily. If the nock has backed out of the arrow or turns easily, inspect the arrow shaft for cracks.

If there are cracks in the shaft, or if the nock is loose or damaged, DISCARD THE ARROW.

WARNING! NEVER SHOOT AN ARROW WITH A LOOSE OR DAMAGED NOCK.

BOW INSPECTION

Before shooting any arrow, inspect your bow and all components to make sure the bow is properly adjusted and in good working order.

Arrows should only be used with bows for which they are properly matched for draw weight and draw length. Selecting the correct arrow spine, arrow length, and overall arrow setup for the bow is the responsibility of the shooter.

Failure to use properly matched equipment could result in personal injury and/or equipment damage.

WARNING! NEVER SHOOT AN ARROW WITH AN IMPROPERLY ADJUSTED OR DAMAGED BOW.

ADDITIONAL TESTS FOR CARBON ARROWS

When checking carbon arrows, perform the following additional tests:

1. FLEX TEST

Grasp the shaft just above the point and below the nock. Flex the arrow in an arc, bending it away from yourself and others, with a deflection of approximately 1 to 2 inches (2.5 to 5 cm).

Feel, look, and listen for cracking.

Perform this test 4 to 6 times, rotating the arrow slightly between each flex until you have inspected the entire circumference of the shaft.

If you hear or feel cracking, or notice any other indication of damage, the carbon shaft may be damaged.

DISCARD THE ARROW.

WARNING! NEVER SHOOT A DAMAGED ARROW.

2. TWIST TEST

While holding the point and fletching ends of the arrow, gently twist the shaft in opposite directions.

If the arrow "relaxes," twists unusually easily, makes cracking sounds, feels soft, or otherwise shows signs of damage, the carbon shaft may be damaged.

DISCARD THE ARROW.

WARNING! NEVER SHOOT A DAMAGED ARROW.

CARBON ARROW CUTTING

Only cut carbon arrows using equipment specifically designed for cutting carbon arrow shafts, such as a high-speed arrow cut-off saw.

Using an improper saw or cutting device may damage the arrow shaft.

If an arrow may have been damaged during cutting, DISCARD THE ARROW.

WARNING! NEVER SHOOT A DAMAGED ARROW.

SOLVENTS

CAUTION: Do not soak carbon arrow shafts in solvents when removing fletchings, wraps, adhesives, or for any other reason.

Certain solvents can weaken the resin that bonds the carbon fibers.

Always follow the shaft or component manufacturer's instructions when selecting cleaners, solvents, adhesives, and other products used during arrow assembly or repair.

WARNING! NEVER SHOOT A DAMAGED ARROW.

IMPORTANT SAFETY NOTICE

Always follow the safety warnings and instructions provided by the manufacturer of your arrows, arrow shafts, components, and bow.

To reduce your risk of serious injury or death, you must read and understand all applicable safety warnings and instructions.

If you do not understand these instructions or cannot adequately perform the inspections and tests described above, STOP and seek appropriate assistance before shooting any arrow.

KUSTOM KING TRADITIONAL ARCHERY
www.kustomking.com